What are the defects in the production of bp500 steel main application

The company has created a group of professional staff with good market awareness and service spirit. More than 90% of the company's employees have college education and more than 3 years of work experience in the industry. Our company has a group of senior professionals engaged in international cargo transportation. Through the implementation of modern centralized control management of the BP500 steel main application whole system computer network, we can effectively control and guarantee the daily operation of the BP500 steel main application. The company is dedicated to provide customers with safe, convenient, economic and thoughtful freight service. The company has always followed the principle of "people-oriented", and created a group of professional staff with good market awareness and service spirit.

19Mn6 steel is common carbon manganese low alloy steel produced according to DIN17155. 19Mn6 steel has strict control over harmful elements sulfur and phosphorus in chemical composition. The mass fraction of sulfur and phosphorus in the steel BP500 steel main application is not more than 0.02%. In addition, vacuum degassing technology is used in smelting, which greatly reduces the gas content in the 19Mn6 steel. 19Mn6 steel has good comprehensive mechanical properties, welding properties and technological properties.

We have 4 typical production lines BP500 steel main application, which can produce hot rolled Seamless, LSAW, ERW and SSAW pipes. The Seamless pipe production line range is OD 10.3mm-965.2mm, wall thickness 1.0mm-60mm, Annual capacity is 500 thousand tons. LSAW pipe production line range is OD 406mm-1524mm, wall thickness 6mm-50mm, Annual capacity is 150 thousand tons.

Preheating cutting: The most effective way to prevent steel plate cutting cracks is to preheat before cutting. Before flame cutting, the steel plate is usually preheated, and the preheating temperature mainly depends on the quality level and thickness of the steel plate. The preheating method can be carried out with flame burner, electronic heating pad, or heating furnace. In order to determine the preheating effect of the steel plate, the required temperature should be tested at the heating point.

DIN 17100 St37-2 steel plate belongs to the carbon and low alloy high strength steel plate. We can supply the different sizes of BP500 steel main application, DIN 17100 St37-2 steel plate. And the rolling size of DIN 17100 St37-2 steel plate is following: the thickness range is 1.2-600mm, the width range is 1220-4200mm, and the length range is 5000-18000mm. Also note that the DIN 17100 St37-2 steel coil thickness should not exceed 25 mm.

Before delivering our hot rolled plate product we apply various tests to check the quality of carbon steel BP500 steel main application plates such as- mechanical test, chemical test, hardness test, toughness test, eddy current test, impact test, micro test, flaring test, flattening test, etc. We are provided best packing for structural steel plates to avoid rust. Our after-sales service team will contact you if you have any question.

Pre:bp500 plate used for safety gate as customers request

NextChina bp500 steel specification steel supplier factory